Truma Stainless flue pipe for Truma fires. 55mm diameter - 1m length image 1

Truma Stainless flue pipe for Truma fires. 55mm diameter - 1m length

£Discontinued
View delivery optionsView product description
  Product Description
Stainless flue pipe for Truma fires. 55mm diameter. 1 metre long only ONLY WHILE STOCKS LAST (for 2M LONG USE CODE 273549 AND FOR 5M LENGTH USE CODE 273548)

Used on the Truma S3002 models and normally installed with ducting 231699 which is fitted concentrically to provide a shield for the hot flue pipe.


PLEASE NOTE THE ENDS OF THIS PIPE ARE SHARP PLEASE TAKE CARE WHEN REMOVING THE TAPE FROM THE ENDS.

SAFETY NOTICE:

All products and parts must be installed by engineers who hold a valid certificate of competence. The installation must comply with the manufacturers instructions and local regulations. We cannot be held responsible if these instructions are not followed.

Please note we are a camping, caravan and motorhome company and NO gas product that we sell is suitable for mains (domestic) gas supply.

1 FAQ on the Truma Stainless flue pipe for Truma fires. 55mm diameter - 1m length

I recently had an accident with a height barrier and destroyed the flue on the roof of my caravan. I have recently purchased a new flue from you to replace the broken one. On fitting the new flue I had to trim back the silver internal flue and it is now approx.15mm short of the lip inside the new unit. Is there any way I can extend the flue or seal the slight gap between the flue and the new fitting.
It is important that there is no gap in the flue as this could introduce flue gases into your vehicle. It is best to have a 'Gas Safe' engineer look at it as he may be able to apply some high temperature sealant if applicable. Otherwise you may have to replace the flue pipe from the fire to the flue terminal. In either case you must have a competent person check the installation with a gas flue analyser. Flue pipe is our part 131698

1 Customer Review on Truma Stainless flue pipe for Truma fires. 55mm diameter - 1m length

Just The Job

by Thewanderer (20 Jun 2013)
5 star review(5/5)
I bought the Truma 55mm flue to use on an old Carver space heater I was fitting in my DIY camper van conversion. The Truma flue is to the same spec and has proved ideal. I felt lucky to have sourced it as I needed just over 3m (the normal Truma kits only provide 3m). It is easy to use, I would always recommend wearing heavy duty protective gloves when working with it as the cut edges are very sharp, the easiest way I found to get a decent cut edge is to put 50mm gaffer tape round the flue where you want to cut it to use as a guide and carefully use a junior hacksaw to cut the flue remembering to then remove the tape afterwards as it is combustible.
  Loading...
If you’ve changed your mind about keeping your purchase, please return it in its original condition with proof of purchase and we’ll exchange or refund it. Unless faulty, this should be within 30 days of receiving your order. By original condition, we’d expect this to mean that you’ve kept packaging and labels, and that the item is undamaged and unused.

For further information of how to return your item, please visit the "Returning an Unwanted/Faulty/Damaged Item" section on our Help Page.
  Did you know we have been established and have been in the caravan and motorhome industry for over 50 years?

RELATED PRODUCTS

Trustpilot

SUPPORT

GET IN TOUCH

Please visit the help page or email us

orders@leisureshopdirect.com

HELP

HELP

INFORMATION

MY ACCOUNT